Комментарии:
Merci pour votre travail. 👏👏
ОтветитьCool
ОтветитьIf Creality is just "Borrowing" What Orca has done and done right why use Creality Print which is nothing more than a buggy Orca Slicer???
ОтветитьI realize that Orca is far superior to CP, but when I print the torture toaster on my new Ender 3 V3, it fails about halfway through using Orca, but prints very well using Creality print. Settings all very similar. It’s failed 3 times using Orca. Have no idea why? Thank you for your videos. I learn a lot from them.
ОтветитьIt has crashed three times on me so far , z offset seems high not getting a good first layer on the k1s
ОтветитьAnd what is now Game-changing on this Build of CP ? I can’t see anything what other slicers haven’t integrated months ago… so no innovation = no game-changer. Why does everyone is wearing out this word by using it without any reasons…
Ответитьla traduction en français ne fonctionne pas on dirais du russe mais en tous cas ça fonctionne pas
ОтветитьI've never got Creality Print to even work on my M1 Mac. I use Cura
ОтветитьAll of this is pretty much open source so anyone can integrate it to their software, creality even said that they use a Slicer That has prusa and orca Slicer code because they are for the community, I personally like the way this new Slicer looks and I'm exited to see they added scarf joints, I like orca Slicer too but I like the interface on creality Slicer better and now I can use scarf joint there too
ОтветитьHas it been upgraded to work with the Ender 3 S1 Plus? 5.0 didn't support it when it came out
Ответить