Комментарии:
While its a cool idea, It does leave visible marks on the outside of the print, you can even see it in the slicer in this example. If you are fussy about look when printed then you would need to not have it so close to the outer edge wall. It would have been more helpful if you had printed two off, one without and one with to see the differences, both visually and for strength.
ОтветитьHow to set up for .8 Nozzle
ОтветитьIs there an equivalent function in Cura?
ОтветитьWould you know of a good laptop or tablet for 3D modeling?
ОтветитьI can't breathe
ОтветитьUntil properly tested this remains an interesting theory. Just increasing the perimeters might be enough to achieve nearly the same result. Hope you follow up with an actual test. :)
ОтветитьHi. Thanks a lot for the info!
Ответить